Universal-remote-control-urs RFX150 Instrukcja Użytkownika Pobierz pdf (Strona 6)

Page 3

MRF-300 BASE STATION

Installation

Step 1 - Set the RF ID # rotary switch on the bottom of the MRF-300 to a

VALID ID# (any address other than ID# 0). If you leave it set to ID# 0, the MRF-300

operates with some restrictions:

a. Accepts RF signals from any 418MH

Z remote control regardless of

the address set when programming the remote control.

b. Front Blaster will be OFF and all IR line outputs are set to ALL).

Step 2 - Mount or place the MRF-300 conveniently and run flashers

to each component’s front panel sensor or connect the Line Out to

a components rear panel IR Input.

Slide off the mounting plate to reveal the RF ID# rotary switch. Use a small flat blade

screwdriver to set the RF ID# to the address you used when programming the remote

control (1-9 or A-F are valid addresses, while 0 is not a valid address).

MRF-300 Manual.qxd 1/14/2005 12:40 PM Page 3

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Brak uwag

Universal-remote-control-urs RFX150 Instrukcja Użytkownika Strona 6